awillis
New Member
So I'm about to do the rod bearings on my 3.2, and I can't find the end gaskets for the oil pan, everyone is out of stock. So has anyone had any luck just using gasket maker instead??
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Yep, no luck at least on their site.Did you try Shosource
are they out of theseYep, no luck at least on their site.
shosource.com
No, I ordered one through AZ, took the 20% discount. Guess I'll hord the rest of the gaskets.are they out of these
![]()
Lower Gasket Kit 3.2L (93-95) SHO
This is commonly referred to as the Lower Gasket Set. It contains most of the gaskets you need if completely rebuilding the bottom end (from the block down). Although there are still a few gaskets that might need to be ordered separately, this is the most complete bottom end kit you can buy...shosource.com
You couldn't have been looking in the right place. Still available:Yep, no luck at least on their site.
shosource.com
I must have over looked, I contacted them directly anyway, and there is limited availability.You couldn't have been looking in the right place. Still available:
![]()
Oil Pan Gasket Kit 3.0L / 3.2L (89-95) SHO
YES, we have a limited supply of these gasket sets in stock. The small tubes of RTV were getting old, so we are now including a 3oz tube or Permatex Black RTV gasket maker. You only need about 3/4oz of sealant, so you will have extra for future projects. This is commonly referred to as the Oil...shosource.com