excidere
Latest activity Postings About
-
-
So another update. I ended up picking up some of the Clevite 1437p bearings. I was able to modify them fairly easily and found the fit... -
excidere replied to the thread Rod Bearing sources.CB-1437p std
-
excidere replied to the thread Rod Bearing sources.I filed both sides to get the hole lined up. IDK if that matters much, a jig sounds way easier. I took it for its first real spirited...
-
New Quaifes are available. Contact them directly. Post in some of the FB groups that you are wanting to buy. You will probably find a...
-
Sorry, compare these two pics instead
-
So I filed a few tonight and this is what I came up with. So here’s the thing. It can be carefully hand filed on both sides of the tang...
-
The main bearing tooling has been destroyed. These will never be made again new. In regards to the rod bearings I looked into as well...
-
excidere replied to the thread Rod Bearing sources.I'd be in for a set or two. I drove it a few more times, still appears to be running fine. The oil pressure gauge reads ~80 on a cold...
-
Good point! It’s not like they have to start from scratch. If they already had the part number they in theory have the tooling on the...
-
I ordered a set of the cb1437-p for the 3.0 going back together right now. The one for the Ranger racer build. So it’ll get some start...
-
Finished porting the heads the other night, and finally got the intake reassembled todayw the BBBs. Pretty happy with how to color...
-
excidere replied to the thread Rod Bearing sources.Also disclaimer: I haven't revved this thing or driven it more than around the block yet. It may blow up in 100mi idk. My plan is to...
-
excidere replied to the thread Rod Bearing sources.A few posts up there's a picture of how I filed down the outer edge to be flush with the bore, leaving enough tang to snap into the...
-
excidere replied to the thread Rod Bearing sources.Updates: I went with the custom filed Toyota 1437p, plastgauge was just over 0.038mm on the car. The 1 Acura I fitted was closer to...
-
excidere replied to the thread Rod Bearing sources.I think the folks from Russia have used the Toyota ones in real cars, they were the first to identify them as a possibility. If my oil...
-
-
Loading…
-
Loading…
