Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
The Quaife will not improve anything. With slicks and good driving, realistically you're looking at 2.1's.
I don't experience wheel hop with my sub par stock subframe.
Let me know when you run 13's in Denver with your current setup. I'll give $2,000.
Offer still stands.
I'll add to that... I'll give you $2k if you can run a 14.4 @ 108+ in Denver with your secondaries unplugged.
What does that have to do with anything? Are you saying your car could not go any faster then a 14.4 in Denver because of the elevation?
Offer still stands.
I'll add to that... I'll give you $2k if you can run a 14.4 @ 108+ in Denver with your secondaries unplugged.
Water injection was not used. Please, by all means, make a trip to Bandimere, you won't run as fast, but I think you'll be surprised.. Like most that haven't play at altitude.Can I play too?
Btw I just noticed I was .8 mph slower than U and it was hot. No charge cooling unlike u ( if u had the water inj then.![]()
I think we both know that my car could have gone faster. I just didn't think I needed to mention that the secondaries we unplugged and I had an electrical short
But if Mr. Traction can do better at altitude, then it wil be out of my wallet.
I never said I could do better at Altitude. Regardless, Altitude has nothing to do with getting traction. Not to mention, with the kind of power your car is making the secondaries being stuck open should have had hardly any effect on power. I know I hardly noticed it when they were stuck open on my near stock 89.
I can agree with that. Check... Inconsistant times equal the 1337 SHO drag racer.I'm not trying to be a dick head here, I'm just saying that for everything that I do not know about these cars (and THERE IS A LOT I Don't know), not knowing how to drag race them is not of them and I will defend and brag about that to no end if I have too.
-Sam
Ask Terry for our comparison dyno. He had functiong secondaries, I did not. I'd say there was a huge difference below 4k RPM. When I plugged them, I went from bogging to 4k to ripping them loose at about any RPM. If you fully understood how centrifugal blowers worked, you wouldn't have made the above post. I believe there is a good thread on secondaries and boost on this very board.
If you're factoring power into the traction equation, I'd say altitude has a small part.
I can agree with that. Check... Inconsistant times equal the 1337 SHO drag racer.