1
14TR
Latest activity Postings About
-
-
114TR replied to the thread Introduction and what I’m working on.Some progress on transmission control. I had considered using the the stock sho ecu to shift the 4r44e transmission via paddle in the...
-
114TR replied to the thread Introduction and what I’m working on.I have a drill, 3/8 impact, 4 inch angle grinder, and the corded surface conditioner in Bauer. Can’t complain about any of them. I do...
-
114TR replied to the thread Introduction and what I’m working on.Hey why pay three times as much for crap that lasts 1.5 times as long?
-
1Based Bauer Chad
-
114TR replied to the thread Introduction and what I’m working on.Just a little sneak preview
-
114TR replied to the thread Conflicting firing order.Success! Well sorta, still completing some wiring and running it on ether since the fuel pump isn’t wired permanently yet, but it did...
-
114TR replied to the thread Conflicting firing order.Thanks bro. The Chilton manual must have it wrong. I’ll try to rearrange and fire it up tonight
-
114TR replied to the thread Conflicting firing order.Dumb question, but since I have everything apart and the coil pack now sits in the passenger compartment on the firewall by the...
-
1This is what I found. Don't know if correct or not.
-
114TR posted the thread Conflicting firing order in Gen 1 & 2 - Engine, Exhaust, Drive Line & AC syste.attempted first start on the SHO ranger last night and it backfired and blew the crossover tube out of the intake and had my ears...
-
114TR replied to the thread Connector identification.And thank you to you too! You were right, somehow I forgot to pull the pigtail for the crank sensor up so it was trapped under the fuel...
-
114TR replied to the thread Connector identification.Thank you!
-
1I have tried to attach the PDF with the connector faces for the 1994 Taurus. This is not SHO-specific though, so keep that in mind. -Rod
-
1The connectors on the engine are both for the CKS.
-
-
Loading…
-
Loading…
