nannho
2010 SHO
Ya its very annoying. For being a CPO car that I bought 3 months ago, I am starting to be annoyed. I think my thermostat went out too!
Think I found the rattle!
- Thread starter SHOrod
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
rcryniak
Active Member
Ticking sound in the dash? You don't happen to live near any rice rocket riding Yakuza, do you? :laugh_ti:
nannho
2010 SHO
ummm...aaaa....i have a rice rocket myself. LOL. But the sho should be uncontaminated,
And more like a light clicking.
And more like a light clicking.
rcryniak
Active Member
Lol... hey, wasn't dissing anyone's choice of ride 
just making a joke about unknown ticking sounds and the Japanese mafia. (I just watched fast and the furious last week for the first time in years. When I first saw that years ago I had no clue what they were talking about, so that was on my to-do list for the past 6 months. Hence the Yakuza reference.)
just making a joke about unknown ticking sounds and the Japanese mafia. (I just watched fast and the furious last week for the first time in years. When I first saw that years ago I had no clue what they were talking about, so that was on my to-do list for the past 6 months. Hence the Yakuza reference.)
nannho
2010 SHO
no ticky, no laundry!
rcryniak
Active Member
Lol :swing:
nannho
2010 SHO
Seems it's possible for the navigation antenna to cause the rattle. Just had a report of that being the problem, in which case the headliner apparently needs to be removed (per the dealer) to replace.
PokerMunkee
I ♥ AWD
When a song with a lot of bass is playing, the window switch/lock panel on my driver's side door makes an annoying rattle. Anyone have this? Not sure how to fix it.
Clear silicone around the edges (quick fix)? Do you see a screw or screw cover retaining the trim panel? On the Edge it is pretty simple, maybe will work for the SHO too.
Window Control Switch
Removal and Installation
Edge only
Pull the switch bezel straight up to unclip it from the door trim panel.
MKX only
NOTE: LH front shown, all others similar.
Pull up on the front edge of the switch bezel and pull forward to unhook it from the door trim panel.
All vehicles
Disconnect the electrical connector(s).
Unclip the window control switch from the switch bezel.
To install, reverse the removal procedure.
Window Control Switch
Removal and Installation
Edge only
Pull the switch bezel straight up to unclip it from the door trim panel.
MKX only
NOTE: LH front shown, all others similar.
Pull up on the front edge of the switch bezel and pull forward to unhook it from the door trim panel.
All vehicles
Disconnect the electrical connector(s).
Unclip the window control switch from the switch bezel.
To install, reverse the removal procedure.
SHOrod
Torrie Tuned
The SHO is opposite of that. On the SHO (at least for 2011) you pop out the rearward end, lift, and slide backward to remove the switch panel.
If you're positive this is the source of the rattle, I'd suggest some thin felt or similar between the switch and the door panel. Although considering the materials used on the mating surfaces, I question that they would rattle. Maybe when you get the switch panel out you'll see something more suspicious.
-Rod
If you're positive this is the source of the rattle, I'd suggest some thin felt or similar between the switch and the door panel. Although considering the materials used on the mating surfaces, I question that they would rattle. Maybe when you get the switch panel out you'll see something more suspicious.
-Rod
Last edited:
Similar threads
