Phoenix
SHOHOLIC
Duplicolor gloss black + SEM clear makes shiny mirrors and door frames.
Bye bye dull'd/sun'd plastic.
Donno if its gonna last but , at least it looks better for now.
12$ And your car looks better....1 pic
- Thread starter Phoenix
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Duplicolor gloss black + SEM clear makes shiny mirrors and door frames.
Bye bye dull'd/sun'd plastic.
Donno if its gonna last but , at least it looks better for now.
Adumb
TSN
nice, and your sig has the before picture,
Phoenix
SHOHOLIC
Ishodu
SHO Member
Looks good, I need to do something with my door pillars, good idea.
Jonny Cash
Good boy
Very clean. good job. Not crazy about the 3.2 decal though.
NebraskaSHO
Harumph!
Looks good, tint would help if it's legal.
Phoenix
SHOHOLIC
Thanks
Yup its underway , with a dyno run. The front sides are pretty much illegal (not really but you just add 10% and you're out of range) and the rear and rear sides , I can paint them , theres no restrictions on these , so Tints will be there soon
hawkeye18
Sorta cares
How did you tape the rest of the car off? I'm trying to get a feel for how lazy I can be while doing this.
Phoenix
SHOHOLIC
I removed the mirrors (Yes you need to remove the whole int door panel.) , for the pilars I only used green masking tape (less sticky) and paper to cover the area. Be very gentle with the spray...more thinner coats>thick coats
DDakRT
New Member
That looks surprisingly good for only $12! Great job dude.
droptSHO
SHO Member
Looks great! I need to do the same. Mine looks horrible now that I have tint.
Adumb
TSN
Funny...this is what I did Friday except I only use Semi-Flat.
it gooes with the wheels very nicely
38SHO
#1 Oil Abuser
nice job, I like the headrests too!
goalieman59
Learning Slowly
do you think this could be done on car with the right taping off? or can someone give a hand with how to get the mirrors off?
93rev2sev
SHO Member
$12 + labor would be what...$400?
goalieman59
Learning Slowly
sounds about right, now we just need to figure out how to pay ourselves to do it.
Phoenix
SHOHOLIC
You can tape it off , if you take the time to tape it really carefully , you will get good results.
HOW TO REMOVE THE MIRRORS:
all you need is a phillips screwdriver and a ratchet with 10mm socket.
Remove mirror cap plastic , one screw.
Remove 2 screws , one above the "thrash bin" of the door , one in the handle to CLOSE the door (not the one to open it) , Then pull the whole plastic piece towards you , it holds only with plastic push pins. Once done pull it towars top to unhook the door lock pin.
I let it hang by the wires but you can unhook them if you like.
Then remove speaker 4 screws. Disconnect the electric mirror connector down below IN the door (windows up). Remove 3 10mm nuts behind the mirror , you might have to tear a plastic thats in the way , if the plastic is already torn , it means someone already played there before you
HOW TO REMOVE THE MIRRORS:
all you need is a phillips screwdriver and a ratchet with 10mm socket.
Remove mirror cap plastic , one screw.
Remove 2 screws , one above the "thrash bin" of the door , one in the handle to CLOSE the door (not the one to open it) , Then pull the whole plastic piece towards you , it holds only with plastic push pins. Once done pull it towars top to unhook the door lock pin.
I let it hang by the wires but you can unhook them if you like.
Then remove speaker 4 screws. Disconnect the electric mirror connector down below IN the door (windows up). Remove 3 10mm nuts behind the mirror , you might have to tear a plastic thats in the way , if the plastic is already torn , it means someone already played there before you
Last edited:
Similar threads
