Please help !!!!

[Jeff93SHOmtx]

Ive got a 93 SHO mtx and i just put the motor back in it.I bought it without a motor got a motor changed bearing etc all that good stuff.I got it all back in the car and together.My problem is im getting no fuel.I pulled the tank check the plug to the fuel pump and I have no power there.I dont know where the fuse or relays are for the fuel pump.I read something about the multi function relay above the radiator and changed that still nothing.

 

[St Louis SHO]

check the powers at the CCRM (the module on the core support)

 

[Jeff93SHOmtx]

Would i pull the harness out with the key on and check each individual prong for power?

 

[St Louis SHO]

you can check it with the module plugged in. is the check engine light on with the key on engine off?

 

[Jeff93SHOmtx]

yes the motor hasnt fired yet i shot it with a little gas through the throttle body and it fired for a split second.

 

[Jeff93SHOmtx]

does that pcm need a ground as well?

 

[St Louis SHO]

Thats the one that bolts to the back of the intake to the firewall.,

 

[Racer X]

Have you checked the inertia switch? Left side of trunk, just behind the wheel well.

 

[Jeff93SHOmtx]

hmm i dont think i have any ground wires off the back of the intake to the firewall

 

[zblackbeast]

Check the fuel pump cut off switch on the drivers side inside the trunk. make sure that button is pushed in. I had that problem when i got my 93's motor back in the car..

 

[Jeff93SHOmtx]

checked it already

 

[zblackbeast]

^^ damn you Hamal.. ha you posted as i was typing!

 

[Jeff93SHOmtx]

i have 2 different ccrm tried em both and still nothing

 

[St Louis SHO]

hmm i dont think i have any ground wires off the back of the intake to the firewall

Well, I'd start here....

 

[Jeff93SHOmtx]

should i make a ground wire and run it from the back of the intake to the firewall or go get a ground strap

 

[St Louis SHO]

use jumper cables for all i care...