on 93 EATC's Where Does the Lighting Connection Go On The Circuit Board?

[BlackOnBlackATX]

ok, long story short i have my eatc apart and im putting the face display back on the circuit board. all is well except i dont see where the 2 pin connection for the lighting should solder in. csn anyone lend some assistance with photos or anything? thanks in advance.
Bob

 

[ohioshodude]

if your doing the eatc mod/conversion you don't need to use that two pin socket anymore. it was just an extention for the two peice lights/board that was there before. hope that helps! thumb

 

[BlackOnBlackATX]

ohioshodude:
if your doing the eatc mod/conversion you don't need to use that two pin socket anymore. it was just an extention for the two peice lights/board that was there before. hope that helps! thumb

well, ill tell you the whole story. i received a hardbutton EATC on ebay. it did not work properly so i figured i would transfer the face of the new one to the working circuit board on my old one. this did not work so i am returning it to its normal state and unfortunately dont remember where the light connections go. im supposed to be getting a new explorer EATC today or tommorow though so im not going to worry about it considering i will implement the mod anyway. but i still am curious where the pins should connect. i had a voltmeter on various locations with power on/off and couldnt find it. if i ever figure it out myself ill let you all know.