mtx experts

[gonetimestwo]

I just finished a clutch job, and a diff pin weld. I assembled the trans, and it works flawlessly, but when i went to put the reverse light switch in (tranny in already). I noticed that the shaft that pushes up the ball on the switch was already 3/4 of the way across the hole (looking in where it goes) I knew right away that the reverse lights would stay on, but checked anyway, and yep. stay on, i just unplugged the switch, but am wondering what I messed up, because the trans works as it should. so im stumped. Thanks in advance.

 

[Wht91+]

I just finished a clutch job, and a diff pin weld. I assembled the trans, and it works flawlessly, but when i went to put the reverse light switch in (tranny in already). I noticed that the shaft that pushes up the ball on the switch was already 3/4 of the way across the hole (looking in where it goes) I knew right away that the reverse lights would stay on, but checked anyway, and yep. stay on, i just unplugged the switch, but am wondering what I messed up, because the trans works as it should. so im stumped. Thanks in advance.

If nobody else knows...try calling Doug at Performance Plus. 1-608-277-8161. leave him a message and he will get back to you. don't quote me on this but i think that he could tell you what happened during assembaly.