Hi.
As you all know, the SHOs get those super sweet heater clusters. We can spin a little wheel, set our desired temperature, and what not.
My problem is my heater. When I run 90° with the fan on Hi and the route being Vent, I get little to no air at all? Heres where it gets weird...
When I click the "OFF" button on the cluster, my heat turns on FULL BLAST, but its not coming from my vents. Maybe Defrost, or Floor, but its definitely blowing, and HARD.
I got some noises coming off my pulley system that isnt natural, doesnt take a rocket scientist to figure that out. Is this entire failure due to 1 pulley ? If so, where is this specific pulley located so I can swap it? Thanks in advance.
P.S. Also is there anything I NEED to know about removing the pulley belt and putting it back on? Any special tools etc?
As you all know, the SHOs get those super sweet heater clusters. We can spin a little wheel, set our desired temperature, and what not.
My problem is my heater. When I run 90° with the fan on Hi and the route being Vent, I get little to no air at all? Heres where it gets weird...
When I click the "OFF" button on the cluster, my heat turns on FULL BLAST, but its not coming from my vents. Maybe Defrost, or Floor, but its definitely blowing, and HARD.
I got some noises coming off my pulley system that isnt natural, doesnt take a rocket scientist to figure that out. Is this entire failure due to 1 pulley ? If so, where is this specific pulley located so I can swap it? Thanks in advance.
P.S. Also is there anything I NEED to know about removing the pulley belt and putting it back on? Any special tools etc?
