SHO bucking!

[cjg92sho]

Those plugs and wires will not work well with the SHO motor. You should replace them with Motorcraft parts.

Who makes the plugs for Motorcraft???? I always thought is was Autolite.

 

[bcdescd22]

OK now when it was idleing every 2 or 3 min the motor cuts out briefly? Still no codes and the following has been replaced,plug,wires,IAC,CPS,CID,fuel filter and the MAF sensor has been cleaned. Any suggestions?

 

[shonole]

When we did my 60k we used Motorcraft plugs and Borg/Warner wires, and it's running SMOOTH so far!

:knockonwood:

 

[bcdescd22]

Should I replace my plug's again? Could the bad thing of spark plug wires foul them out?

 

[Huntervf]

No, plugs should be fine. If it were still idling rough that would be one thing, but a stumble every few minutes sounds like a separate problem. Sounds like you've replaced most of the trouble items already When you pull codes does the computer do anything strange? I had a 95 ATX that had weird idling problems and when I'd pull codes the computer acted a little different than normal... sometimes it wouldn't run a KOER test, and it would never run a goose test. I was suspicious that the computer was bad, got a replacement and voilla, all problems solved.

It doesn't sound like you have a comp problem, but just the same be aware of how it acts when pulling codes. Does it go through all the modes ok?

 

[bcdescd22]

Yea when I check the codes everything is fine. The idle seems fine you can tell its surges very little but it wont be perfect.

 

[bcdescd22]

I did see a couple of lil black specs in the coil pack where u plug them in? I guess next step is a coil pack?