service manual body information

[ELMACHOGERACHO]

i just recently purchased a 92 white sho, and it has several body panels from a normal taurus on it. i found someone locally who is parting one out and im going to go pull parts. i know how and what i need to remove the hood, but im looking for bolt sizes to remove both front doors, both front fenders, deck lid, and ignition cylinder.

thanks for any info

 

[rubydist]

the ignition cylinder comes out by turning the key to the 'on' position and inserting a small allen wrench (likely the smallest one you can find) into the little hole in the bottom of the cylinder - you can see there is a small hole in the steering column cover into which you insert the pin (allen wrench) and push it up until the cylinder is unlocked and slides right out.

the doors have 4 bolts each, you can figure out the sizes on your current car.

the fenders come off w/ mostly 8mm wrenches, you may need a 10 as well, and you may need a 5 or 5.5mm and a phillips screwdriver, depending on if the fender liners are held in with factory fasteners or others. you basically need the front bumper and the rocker panel trim off prior to being able to remove the front fender.