long Road

[platoribs]

Check your wire sequence on the DIS... I gotta dollar says it's wrong!

Quote from SDPatt:
The wiring arrangement in the Chilton's manual is wrong, but so is the sequence shown above. The correct order is shown below.

Engine
Firewall
1-2-3
-----
4-5-6
Radiator

Coil Pack
Firewall
5 | 1
6 | 2
4 | 3
Radiator
__________________

Ask me how I know hooking it up wrong will cause a glowing red hot Cat!

 

[SubCool]

Check your wire sequence on the DIS... I gotta dollar says it's wrong!

Quote from SDPatt:
The wiring arrangement in the Chilton's manual is wrong, but so is the sequence shown above. The correct order is shown below.

Engine
Firewall
1-2-3
-----
4-5-6
Radiator

Coil Pack
Firewall
5 | 1
6 | 2
4 | 3
Radiator
__________________

Ask me how I know hooking it up wrong will cause a glowing red hot Cat!

I love you.
Working GREAT now.
Puffing alot of smoke tho. I mean ALOT. When i started it up.. TONS. every time i start her up... i get a good amount of smoke. Than again i also have alot of injector cleaner.

SO, no backfires. No bogging. Its great. I think i may adjust my MSD because i think i have the cut too low. But, w.e. I still ahve to mount it.

 

[SubCool]

I am just noticing how my last post didnt post.

Well, for my update.
I just did the Radiator Flush. - she is running hot still
And, she is mis-firing. Its very weird. Its occasional, not too frequent, but enough to aggrivate me. Tomorrow i am going to go and take a look at the plugs. See if any of them are fouled up.

The check engine light is goin to remain on since i have the MSD isnt it?

Once again guys, any help is always appreciated.

**Next Day***

I drove down the rd. and she bucked a lil, and mis-fired.
I picking up my mom's bf. And .. all **** broke lose.
She bucked like a broncho, Mis-fires all the way.
Turned her off for a lil, Disconnected the batt.
Turned her on.
At idle. she is fine, a lil backfire.. very minimal. Once i apply a load(a gear), She bucks. I am waiting for her to cool down again, so i can try and check those plugs.

*** later On***

I Checked the plugs, They are fine.
I Changed the fuel filter.

Same Thing. I am about to go and take it for a test spin, again.
But i dont think anything will Change.

HELP!!!!

 

[SolidState]

plug wires.

And put the stock DIS back in. and make sure it is grounded.

 

[SubCool]

plug wires.

And put the stock DIS back in. and make sure it is grounded.

I am looking to order a By-pass for the MSD.

 

[SubCool]

Good looks,
My CID was faulty. I am getting a new one tomorrow (i hope)
That should take care of the rest of the problems. I ran the codes finally.
I have a problem with my PIP, and IDM - but thats because of my MSD.
My Fuel Pump is funky, but i knew about that. Nothing severe. the MAP, or BORA is faulty. No super whoop. Kinda expensive tho.
That really Covers it all for now. I Will have another update tomorrow, after i install the replacement CID, and pray a lil.

Thanks guys, Looking up!