SHODWN
Mother Threasa
Well seeing that it will be much warmer im heading up again this Wed. I hope for better results this week after finally almost figureing out the tables for adjusting "things".
Last drag night for NED this week
- Thread starter SHODWN
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
frosho
WOLFMAN
Yes! I was hoping to give it one more go as well. This time the seats are coming out, I want 14's.
Mr Anonymous
Tire Wall
Fine, I'm taking my hood and doors off and letting Cote drive my car!
frosho
WOLFMAN
Hey, you've got over 24 hours to prepare. Should be plenty of time to swap in an MTX. 
SHODWN
Mother Threasa
He will get back to you, he took a whole package of ex-lax to prep for tomorrow night.
jmpSHO
SHO Member
Anyone have a battery hold down I can borrow?
Racer X
SHO Pilot, Retired
I have a MTX tray and hold down, but not the threaded rods and nuts.
I take it that bungee cords won't pass tech?
jmpSHO
SHO Member
I never been to New England drag and I don't want to chance not being able to run my car because I have bungy cords lol. I actually have a battery hold down but I don't have the bolts for it.
ryan21288
New Member
They passed me with a ratchet strap lol so i know for a fact they will.
frosho
WOLFMAN
They just grab the battery and give it a good shakedown. A ratchet strap isn't a bad idea, they're pretty strong. Bungees have more give and will allow more movement than straps though, so I wouldn't want to chance it with those. Probably depends a lot on who you get for an inspector.
Case in point- I mentioned my lightweight flywheel during tech on two different occasions. The first time, they guy couldn't give two ***** and passed me no problem. The second time, the kid asked me if it was approved by some organization or something. I had no idea what he was talking about, so I nodded and said "yes." Apparently I wasn't very convincing because he walked off to speak to one of his superiors about it. He still passed me, it just took longer. Moral of the story: keep your mouth shut during tech.
Case in point- I mentioned my lightweight flywheel during tech on two different occasions. The first time, they guy couldn't give two ***** and passed me no problem. The second time, the kid asked me if it was approved by some organization or something. I had no idea what he was talking about, so I nodded and said "yes." Apparently I wasn't very convincing because he walked off to speak to one of his superiors about it. He still passed me, it just took longer. Moral of the story: keep your mouth shut during tech.
Last edited:
frosho
WOLFMAN
Don't make me cut my hair.
medgraphsho
Bill T.
.Fine, I'm taking my hood and doors off and letting Cote drive my car!
thats 300lbs. less right there
frosho
WOLFMAN
Similar threads
