Koni Install...

[PMD Power]

is it really as hard as it sounds? since you have to use the sturt housing... Or would it be worth my money to just pay the 30 bucks a strut from shoshop or where to have it doen for me?

 

[gdsqdcr]

IF you can find a place to put the struts in for 30 bucks a strut ... go for it. I did mine myself, (springs, struts, bushings ... ) took me 10 hours.

Anthony

 

[PMD Power]

Well the inital install is not what worries me.. it is the whole reusing the housing thing.. I dunno what that really means being I never did struts before... if it is too much of a PITA then I will get Tokico and have a slighty spfter ride

 

[gdsqdcr]

I cheated and ordered my Koni's, I had them installed into housings before I got them.
I am sure someone on this list has done it, I have been told this is not a very hard thing to do.

Anthony

 

[PMD Power]

gdsqdcr:
I cheated and ordered my Koni's, I had them installed into housings before I got them.

Anthony

I think I will do the same thing.. to save some time... would it be okay to get the Intrax springs first then a month or so later get the Koni's?

<small>[ May 16, 2002, 03:04 PM: Message edited by: PMD Power ]</small>

 

[gdsqdcr]

If you are planning on doing struts and springs .. do them at the same time. Save yourself a bunch of time ...

Anthony

 

[PMD Power]

it's not the time I am worried about.. it's the money .. I don't wanna have the new springs get messed up fromt stock struts and vice versa.. if worse comes to worse I will just have to wait till I have the money for both at once

 

[Aspect]

Wait till you have the money to do both at the same time. The labor costs will be much higher (and having an alignment done twice)by doing them seperate.

 

[PMD Power]

well I will be doing the install part myself.. I just didn't know about the reusing the casings... but I do understand the point for the alignment.. I didn't think about that.. no point in getting one twice