Keyless custom...

[MYSHO1]

Working on a custom keyless for the car that will get the doors to pop open. The doors/trunk/antenna...EXT Now i want to shave the keyless also and move it to the pillars like the newer fords.. Does any one know if the wires are the same so all i have to do is splice the wires?

 

[Jonny Cash]

Pat, why wouldnt you just take the one you have, lengthen the wires, take the pillar cover off, and cut the space in the pillar?

 

[MYSHO1]

the numbers on the new fords go like this
1/2
3/4
5/6 Ext

on sho,s they go 1/2 3/4 5/6/.. ext

The new ones go up and down, old ones across...

 

[SASHO91]

so you want to do all that work just to have the numbers vertically instead of horizontally....

dont get me wrong, it would look really nice, and be different. its just not my cup of tea.. pulling the old (working) one out, just to have them vertical. i mean, the other extra stuff would be cool, but still...

either way...good luck with it ...

 

[SolidState]

I thought about trying this too, but I don't think there will be any room for it on the pillar...

looks nice on the explorers though....

 

[MYSHO1]

Im not sure about room, I will honesty say i this is one part of what i am doing i did not look very far into yet.

 

[SHO92]

The door pillars aren't hollow, so the electronics & wires would be seen when the door is open. Also if you've ever taken a keypad apart, you'd know that its about an INCH!! thick.

I'd just leave the keypad on the door...

 

[SolidState]

yep, that is where I was going with this...

 

[MYSHO1]

I might loose it all and all then... Im shaving everything...