help! need belt for udp. what size?

[93fordsho]

So I just put my udp on here at work and I don't know what size belts I need. I need help ASAP! Thanks guys

 

[Eric VerValin]

If you only have the one, you should almost be ok if the tensioner is all the way down... not positive tho..

 

[SuperHO]

i was able to use the stock sized belt for the water pump/power steering, though it took a little fanagaling to get it on. i can't help you with the altenator pulley as i don't have A/C.

 

[SHOtime2511]

Place your tensioners in the middle of there adjustment range.
Grab a some string or fishing line and go around the pullys just like each belt would and mark them.

 

[AREA 91]

So I just put my udp on here at work and I don't know what size belts I need. I need help ASAP! Thanks guys

I have the SHO SHOP 3 piece pulleys on my cars.
The belt number's for these are:
K060455 (6 rib)
K040510 (4 rib)

 

[Eric VerValin]

I have the SHO SHOP 3 piece pulleys on my cars.
The belt number's for these are:
K060455 (6 rib)
K040510 (4 rib)

Same #'s for the 4 peice..

 

[tompumped]

In case anyone cares I put the recommended belts on a shosource udp, and with the tensioners maxed out I still couldn't get proper tension, but there's enough I guess. I doubt anyone uses a belt tension gauge to check, but I do. I got the part numbers from shosource.

Next time i'm going to get shorter belts and post back.

 

[Phoenix]

Just measure it up and call the part number , The K numbers - last 3 digits are the length of it , a 455 belt is a 45,5 inch , and the 06 is the number of ribs.

Since i got a custom belt setup , I used a old belt , cut it at one end and use it as a template to know how long you need...

 

[93fordsho]

Cool thanks guys. I ended up just calling everyone in the Colorado springs area till I found the ones that fit. I'll post the lengths later so if anyone else is ever wondering its there

 

[silverbullet92]

What did you find for the belt length for the Sho Source pulley?