Common jobs that are harder to do than rod bearings.

[93rev2sev]

Power steering pump replacement.

Your turn...

 

[FREAK_SHO]

Water Pump

Next

 

[Mr95Gl]

Rear struts on rust belt cars.

 

[dmoo21]

subframes...


nex to the t

 

[thecrew2999]

engine rebuilds... o common jobs and this is a yamaha engine not a ford.. my mistake.

 

[NCTaurusSHO]

pushing the pistons in on the rear calipers after they have been pushed out due to bad brakes....

 

[TYSHO]

Rear struts on rust belt cars.

x2

Turned into replacing knuckles, too.

 

[thecrew2999]

wheel bearings when they go i would say are a pain in the ass... at least more so then the rod bearings..

personally bearings are easy, y pipe, oil pan, griddle and just take the caps off the rods.
course make sure you got a tq wrench with the right sockets haha.

 

[FREAK_SHO]

Blend Door

 

[Off Road SHO]

Anything on the underside of rustbelt cars.


Tom

 

[FREAK_SHO]

Anything on the underside of rustbelt cars.


Tom

So true.

 

[Mike Kelly]

Heater core.

 

[dmoo21]

pushing the pistons in on the rear calipers after they have been pushed out due to bad brakes....

x2

cube tool FTL

 

[NCTaurusSHO]

haha.. yeah we have the tool..still a b*tch. haha -ashley-

 

[ritmusic2k]

Vacuuming my floor.

Oh, wait... car stuff?

Um, replacing brake system hardlines (just my personal experience, maybe some of you found it to be easy)... and actually, that's probably not too common of a job. I give up. Next!

 

[TYSHO]

haha.. yeah we have the tool..still a b*tch. haha -ashley-

Don't buy the cheap POS kind that go on the end of a rachet extension. Buy/Rent the kit from AutoZone and be done with a caliper in 10-30 seconds.

 

[SHOBlu]

Opening the passenger rear door on my MTX. (still not open after 2 cans of PB Blaster and an hour or so pushin', bangin', kickin', and hip checkin'.) -POS

 

[Howdy_Doody]

Replacing y-pipe studs that break while doing rod bearings.

 

[FREAK_SHO]

Steering Rack

 

[Mr95Gl]

Rear plugs on an MTX, with the intake ON!