#3 and #6 not getting spark at the coil

[dgldeuce]

I recently purchased a '93 with 3.2 and have had nothing but problems trying to figure this thing out. I have replaced the MAF sensor, the coil pack, plugs, O2 sensors. Wires look to be in good condition. It runs VERY rich and smell raw fuel, but I'm sure that is due to #3 & #6 nto firing at all. Fuel milage is terrible but I'm not dringin it anymore since I found the misfire.
Any suggestions--I have read everything from DIS to Knock sensor but where do I start?

 

[projectSHO89]

Replace the DIS module. I'd also bet your tach is showing only about 2/3rds of the actual engine speed. If so, this confirms the DIS is faulty.

Steve

 

[dgldeuce]

It was the Ignition control Module