3.0/3.2 Build 250hp+ dyno tested engine.

[FRANK FORD]

so I'm looking to install or repower a 1988 ****** gt with a SHO engine so I'm looking to buy a already build engine with the bigger cams
and lots of go fast parts you know that engine you have wrapped up under your work bench and will probably never use even though its
a very good engine well I want that engine.

I need cheap but fast like a 3.2 with tri-flow cams with many more go fast parts N/A is what I need but I would take a turbo setup too.

I'm willing to drive 1000 miles from Montreal quebec or Ottawa Ontario.

tell me what you got.

 

[FRANK FORD]

back to the top.

exp: tri-flow cams

 

[FRANK FORD]

I need a Engine guys sell me a good powerful engine.

 

[Irish Pride]

I have a freshly assembled high compression 3.3 that will exceed your HP requirements but I'm not within 1000 miles of Montreal and it won't be cheap. Currently wrapped up under my work bench.

93.5mm bore, 11.5:1 compression Wiseco pistons, ported/gasket matched heads, SHOnut +10 cams, NOS main bearings, NOS rod bearings, etc... Built it and then set it aside as something else presented itself.

-Chad

 

[FRANK FORD]

Thanks guyd found a engine , took compresion today and it was 210psi and all six cylinders thanks guys.
Yes engine is from a forum member on here. he has a nice ShoGun reproduction. top notch.

 

[Irish Pride]

Thanks guyd found a engine , took compresion today and it was 210psi and all six cylinders thanks guys.
Yes engine is from a forum member on here. he has a nice ShoGun reproduction. top notch.

Must be Jonathon Richard.