wiring braket at rear valve cover

[shoclown]

i am in the process of replacing the the top end of one of the 89s, i removed the intake and cylinder heads to do valve job bbb etc. I had the syudents pull it apart and now i am putting it back togather. i did not pay attention to where the wiring went before tear down. the bracket in question is on the rear head. it is a bracket about 8 inches long has 4 connectors housed in it. my question is does this bracket bolt to the head where the p/s line bracket and the intake supports go? or does it go on the back of the intake plenium where the top of the strut goes with the ground?

 

[SHOtimer]

It bolts onto the rear of the head and sits ontop of the valvecover. It does not attach to the intake.

Doug

 

[shoclown]

does it only have the one bolt

 

[SHOtimer]

That I don't remember. You should be able to tell by looking at it.

Doug