WIPER SPEED

[Jayman]

Okay I've searched under wiper, stalk and multifunction and did not find a solution to my specific problem.
My wipers work fine (spray/wipe from off, intermittent etc and low speed), except when I select the high speed position it continues at the same speed as the slow.
Should I be looking to clean my switch on this one as well?
Thanks all,
Jayman
squint

 

[SHOZ123]

Yes the high speed contact is gunked up in the MFS

 

[sdpatt]

I searched on "clean multifunction switch" and received the following link: link1. If cleaning the switch doesn't correct your problem, it may be a hardware fault and would require that you replace the switch.

<small>[ November 22, 2002, 08:26 AM: Message edited by: sdpatt ]</small>

 

[Jayman]

Thank you! I shall go ahead and clean it out. It would seem a shame to have to buy a new one when it works great except for the high speed position.
Jayman