Does anyone know how to tighten the shifter? Mine is getting loose and will rotate left and right. I think the center chrome trim piece pops off, but not certain. Hate to make a run to the dealer for such a little thing!
TIA!
TIA!
Shift control
- Thread starter Retnavy
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
lowc
aka vapah lock
ii would take it to the dealer just because if there are any further isseus with it they cant say well you fd with it so now its ur problem
itguy08
Member
Mine too and I was wondering the same thing. Feels like a screw may have worked itself loose after the pas1 1.5 years. It can't be that hard and would hate to waste the time to tighten a loose screw.
jmpSHO2nd
SHO Member
Anyone figure out how to tighten the shifter thi cong phim truong.
Last edited:
SHOrod
Torrie Tuned
According to the 2010 and 2011 Factory Service manual:
1. Slide the selector lever **** bezel down to access the 2 selector lever **** screws.
2. NOTE: If equipped with a Transmission Control Switch (TCS), do not pull the selector lever **** off of the selector lever.
Remove the 2 selector lever **** screws.
Vehicles equipped with paddle shifters
3. Remove the selector lever ****.
-Rod
1. Slide the selector lever **** bezel down to access the 2 selector lever **** screws.
2. NOTE: If equipped with a Transmission Control Switch (TCS), do not pull the selector lever **** off of the selector lever.
Remove the 2 selector lever **** screws.
Vehicles equipped with paddle shifters
3. Remove the selector lever ****.
-Rod
Similar threads
