OK, I can not pull codes????

[Fusion]

Not sure on this one. I followed the instructions form Mr. Anonymous links in his sig and nothing. I even went so far as to make sure the battery has a full charge. Jumper wire in, no "check engine" blinking. Tried a test light from PIN 4 and no dice. Any ideas??? shrug

 

[Xs SHO 1]

check the check engine light bulb to see if it burned out....

 

[Fusion]

Not burned out...

 

[Dr. Tweak]

Try mine maybe?

 

[40BelowSummer]

make sure you have the right pins jumpered. when i did it i had the connector upside down compared to the pic. sometimes its the simplest things oh

 

[qiksho]

could be your computer

If the car will start and run...I am sure its not, but...

 

[projectSHO89]

Fusion:
Not sure on this one. I followed the instructions form Mr. Anonymous links in his sig and nothing. I even went so far as to make sure the battery has a full charge. Jumper wire in, no "check engine" blinking. Tried a test light from PIN 4 and no dice. Any ideas??? shrug

More specific information and troubleshooting is needed.

The CEL should be lit as soon as the key if turned to RUN before the engine is started. Does yours come on?

What exactly are you referring to - "Pin 4"?

Steve

 

[Fusion]

I did it EXACTLY as shown in this Pic,

The CEL will light up breifly when I flip the key, so I know it is not burned out.

No Car does not start, read about it here.
http://www.shoforum.com/ubb/ultimatebb.php?ubb=get_topic;f=49;t=000013

<small>[ March 09, 2004, 08:39 AM: Message edited by: Fusion ]</small>

 

[Fusion]

guitar333:
make sure you have the right pins jumpered. when i did it i had the connector upside down compared to the pic. sometimes its the simplest things oh

Good Call, I feel Dumb

I pulled a 114 and a 116.

114 is a air charge temp sensor, this is the sensor in the air box right? I do not belive this is the problem.

116, Looking at the codes page, there is no code for a 116, just my luck
http://www.shotimes.com/php-bin/modules.php?op=modload&name=News&file=article&mode=thread&order=0&thold=0&sid=84

 

[Fusion]

OK, Found it on another link

116 (O,R) Engine Coolant (ECT) sensor out of range - ECT

114 (O,R) IAT sensor out of range - IAT


I really do not belive that these woul be causing my problems

 

[projectSHO89]

Fusion:
OK, Found it on another link

116 (O,R) Engine Coolant (ECT) sensor out of range - ECT

114 (O,R) IAT sensor out of range - IAT


I really do not belive that these woul be causing my problems

114 - If colder than 50 F ambient, ignore.

116 - If engine is not at operating temperature, ignore.

Did you ever get this thing to start? If not, just ignore both of those codes.

Steve