no power locks or power seats on 92 SHO

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

gmail

Well-Known Member
Joined
Jun 25, 2008
Messages
870
Reaction score
290
Location
sunbury pa
as the title says i have no power to door locks or power seats and i havent for over a year now on my 92 SHO.

i played around before with a few things in hopes of fixing it with no luck..

i know they share a common ground which is at the drivers seat near the trunk and gas door release which i checked that a year ago and i did again today as i cleaned it up and sanded the paint down where the ground lug bolts to the car also applied some dielectric grease to keep it from getting nasty now that i sanded it down.. nothing but the weird thing i noticed was when i had the ground off the interior lights dimmed as well as the dash lights and such and the drivers door made a ticking sound, when i hit the door lock or power seat buttons it made all the lights get bright again but still did nothing like its should.

i then took off all the connections cleaned them and added more dielectric grease to them plugged them back in and still nothing..

also in the past month i installed new doors and cleaned all the connectors up there as well as checking fuses probley 30 plus times.

the only thing i can think of is somewhere a wire must be shorting out.
i guess my goal with this is to see if someone had the same problem before and found a solution like maybe i have the same issues as them..

the only thing i got left to door is take the car apart the rest of the way and sit out there with my multimeter checking every wire and pulling them all out of the harnesses.

only thing i kept thinking was a issues was the fact the car had a car alarm installed from one of the past 13 owners (yeah its been around the block) it wasent a real bad install job but they did use crimps which i dont like to use personally but also i took out the relay junctions they install on the wires and soldered and shrink wrapped them back to stock...


thanks in advance if anyone can help
 

gmail

Well-Known Member
Joined
Jun 25, 2008
Messages
870
Reaction score
290
Location
sunbury pa
if someone could also post some wiring diagrams.. i got a ford service cd but i cant find it right now so that dont work out..

thanks
 

gmail

Well-Known Member
Joined
Jun 25, 2008
Messages
870
Reaction score
290
Location
sunbury pa
also i almost forgot i replaced the keyless box in the trunk and no difference
 

gmail

Well-Known Member
Joined
Jun 25, 2008
Messages
870
Reaction score
290
Location
sunbury pa
got a little closer....

tested the power with the multimeter to the seat power which is only positive and negative and they are both grounded... i started to cut the wiring harness open and the wire going to the passenger side black and white i didnt get to check because im sweating like crazy but the black wire which is factory ground goes to the drivers side into a bundle of other black wires or ground wires so im assuming its all good there considering this is my only issue...

once i cool down some im gonna check the black and white wire going to the passenger seat after i remove the pass seat and center console......
 

gmail

Well-Known Member
Joined
Jun 25, 2008
Messages
870
Reaction score
290
Location
sunbury pa
lost my dash lights now and im not sure why....

looks like im gonna be pulling the dash at some point now....







if someone got a wiring diagram id love you very much....
 
Last edited:
Back
Top