Neat pic while packing the garage...

[etc1006]

I slid the front Saleen ground effect piece under the front of the SHO for kicks the other evening. Looks pretty Bad a$$. Yes my 92 LX was DEG... Didn't have any boxes handy to put it up against the b/c... The corners are more rounded on the SHO, too. THe wheel well wraparound met up "okay", though... The pic of the rear was too dark.... Just havin' a little fun while packing. Maybe someone can photoshop it "up" there?

 

[Minnesho]

i did that once with a lower valiance from a fox body GT, it didnt fit quite as good as that one though.

 

[Minnesho]

BTW, holy hood gap batman!!

 

[etc1006]

Can't do much more about the gap... I pulled the core as much as it's gonna pull. You can see the left side has a little more than the right, too... From an accident a P.O. had. From what I can figure they poked a trailer hitch or the like dead nuts in the left H/L judging from the scratches on the bc and where the core is beat up and where the original hood was bent...

 

[1993MTXSHO]

heres a very sad and i mean very sad attempt of putting that valence on the sho, did it in 5 min using paint haha. It might get the point across I think someone can do it better, I know i could if i had photoshop on this computer. It looks better in the thumbnail you cant see as many imperfections.

 

[Minnesho]

LOL, seems like it would look decent though, as long as the side cladding matched up fine

 

[Jonny Cash]

BTW, holy hood gap batman!!

that could be worked out fairly easily.

I say try it.

 

[etc1006]

That valence don't look half bad! I'd prolly ditch the fogs on it, though. The Taurus corners were waaay more rounded than the Mustang. JC as far as the adjustment, no time(packing), too hot to worry about it now also! I was more concerned at the time of getting it roadworthy. You should of seen me trying to align the headlights before the core pull! I ended up stripping the philips head adjusters to boot. I replaced them all with the small hex head ones.