Wondering where to start to find the rubber “boots” for the intake manifold. Not sure exactly what they are called but there a 9 of them all together. 3 on each side 2 in the rear and 1 in front. ‘93-3.2. TIA.
Last edited:
Looong Shot
- Thread starter torotoro
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
luigisho
SHO Member
https://shosource.com/products?keywords=coupler&olsPage=products/sho-source-v6-intake-coupler-hoses-89-95
They are not the exact same but they are the only replacement available off the shelf.
They are not the exact same but they are the only replacement available off the shelf.
Thank you Luigi. I am looking into this for a friend. If he wanted to, do you know Where would one get them custom made?
luigisho
SHO Member
You would have to purchase something like silicon hose of the correct diameter and get the correct cutter to cut them properly. I used to know this stuff but this was tackled so many years ago that it's evaporated from my brain. It may be archived somewhere. For the price and time, I would probably just pull the trigger on the ready to go stuff.
Thanks again!
luigisho
SHO Member
Just FYI if you pull off one of the old ones you will see they were molded in a funky design that no aftermarket would sell if they had to develop that mold-- so just straight hose for new replacements.
You will need to reuse the biggest one, Nick Chrimes noted that on one of his post
Thank you. I will pass that along.
Similar threads
