Butterfly to plenum gasket.

[1-92MTX]

During the process of cleaning out my intake manifold and getting my butterflys out to hopefully be bored to 40mm, i broke my butterfly to plenum gasket in a newbie mistake its not broke around any of the three openings, so im not sure if its a problem but i havent been able to find this gasket, anyone have any suggestions?

 

[rcsavage]

maybe try to find some thing like liquid gasket maker. ive seen it before so it does exist. if you want a new one, you have to buy the intake gasket set from rcm. http://home.earthlink.net/~rcm_automotive/id10.html

 

[ohfosho]

its in the upper intake gasket set...not sure if you can buy it seperatly.

 

[jedhead]

You can make your own gaskets. I made my own throttle body gasket. I cut out a piece of manila folder larger than the gasket I want to make. Get a very small ball peen hammer. Place the piece of manila folder over and tight on the surface of what you want to make a gasket. With the round side of the hammer tap the manilia folder against the sharp edge and hammer out the pieces. Put some RTV on both sides.

Bob

 

[F-22 Raptor SHO]

Ditto what bob said. There is a roll of black paper gasket material you can buy from autozone for 6.00. Has enough paper to make a butt load of stuff.

 

[1-92MTX]

Well ain't that handy to know?
Problem: Solved
Thanks for the advice!