ABS Sensor Splice

[SHO_OT_ME]

Is there any good way to splice an ABS Sensor wire? I has to cut mine cause the sensor was rusted tight to the knuckle. I replaced the front right wheel bearing and that was the only thing keeping me from removing the knuckle.

Be kind to me cause I searched and didn't find anything and this is my first post since I bought the SHO.

Thanks for all the help on this forum. It's helped me pick the car and got me thru a thermostat replacement. This made the difference between picking a POS and getting the SHO. I now feel I can find a way to fix anything that goes wrong with this car....

Thanks

JW

 

[Mr Anonymous]

If the sensor is still good, you should be able to splice it without much problem. I'd recommend using solder to make the splice, and two layers of shrink tubing (one over each splice, and one large one to cover those splices -- making it appear to be one whole wire again). If you need to replace the sensor, the connector is inside the engine compartment to the front side of the strut tower.