Heated seats not heating

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Majestic

SHO Member
Joined
Aug 28, 2016
Messages
1,281
Reaction score
1,024
Well, that didn't fix it. Press the seat button on the display, it lights up, fans spin up for about a minute and then shut off :( Looks like I'll be looking under the passenger seat when it gets a bit warmer around here.

Thinking about the mirror output code, I remember noticing a few days ago that the passenger mirror puddle light isn't working. Wonder if that's related?
 

Johnbigdog

SHO Member
Joined
Feb 17, 2017
Messages
1,417
Reaction score
1,703
Location
michigain
There was a seat heater overtemp detected, which I cleared and will see if that corrects the issue. The only other DTC is b12d8:13-2a - mirror heater output, circuit open. That comes back each time I cycle the ignition and scan. Wonder what that's about?

The b12d8:13 is a dtc for the heater around the IPMA. Thats the camera in the windshield for auto high bean and lane keeping if you have it.

The seat over temp could be realted to poor air low across the ted causing it to overheat or maybe a circuit fault for the temp sensor not reading properly, maybe a circuit fault putting too much power to the ted itself.
 

Majestic

SHO Member
Joined
Aug 28, 2016
Messages
1,281
Reaction score
1,024
The b12d8:13 is a dtc for the heater around the IPMA. Thats the camera in the windshield for auto high bean and lane keeping if you have it.

The seat over temp could be realted to poor air low across the ted causing it to overheat or maybe a circuit fault for the temp sensor not reading properly, maybe a circuit fault putting too much power to the ted itself.

I'll be flipping the seat tomorrow to see if the harness is burned up like the one in the link I posted. I was wrong that the rear seat heaters were not working; they do. Just the fronts are not working. I'm going to also see what is up with the puddle light not working.

I don't have lane keeping assist but I do use the auto high beams all the time and they work fine.
 

Majestic

SHO Member
Joined
Aug 28, 2016
Messages
1,281
Reaction score
1,024
Well, the harness looks fine. Not burned up at all. Kind of at a loss on what to check next. I suppose I could replace the module, but I kind of hate to spend the $ and that not be the issue.
 

Majestic

SHO Member
Joined
Aug 28, 2016
Messages
1,281
Reaction score
1,024
Check fuse 28 under the hood. 30 amper. Sometimes just pulling it out and putting back in fixes the issue. Happened to me a couple times. And hopefully its not your module, ill check tasca for pricing just incase.

https://www.tascaparts.com/oem-parts/ford-seat-heater-control-module-bu5z14c724a

I kinda doubt its a module, because then it would be all of them bad at the same time

I wonder if this module interchanges? Same part number except it begins with G instead of B:

https://www.fordpartsonsale.com/oem...b1nF5ibqh0iGXBUZT0wwkMgenkjnSf2xoCm24QAvD_BwE
 

Majestic

SHO Member
Joined
Aug 28, 2016
Messages
1,281
Reaction score
1,024
This car is bizarre... seat heaters are working fine now. Maybe the plug was just loose, somehow?
 
Back
Top