Gen 1 Gauge Pod
- Thread starter TYSHO
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
K-Dawg
SHO Member
I'm pretty sure the Taurus gauge pods were designed to go over the factory A-pillar trim. I think the Gen 1 and Gen 2 pods were made by Lotek (gaugepods.com) and SP Motorsports resold them.
Unfortunately, none of these pictures show the gap on the Gen 1 pod. In SHO AMO's picture, you can see where the gap is on the middle and bottom gauge. If the picture was taken looking into the car, you'd see it.
Unfortunately, none of these pictures show the gap on the Gen 1 pod. In SHO AMO's picture, you can see where the gap is on the middle and bottom gauge. If the picture was taken looking into the car, you'd see it.
blacklabel
Member
I think I know what you are talking about. There is a gap on it that kinda reveals where the wiring is routed. I mean it isnt terrible looking, just would look a lot cleaner if it was flush with the surface.
Racer X
SHO Pilot, Retired
If they were, then I dun goofed.
That said, I installed mine in place of the stock A pillar trim, and there are 0 gaps, 0 visible wires... it's looks stock, for all intents and purposes.
K-Dawg
SHO Member
The Gen 2 pod fits fine. It's the Gen 1 pod that looks like crap when you open the door.
jelloslug
Digital
Not to mention that the texture is all wrong too.
Similar threads
