writeups/how to/DIY on...

[gimpy]

Meth injection installation.

Like with my other thread, I'm ready to purchase the Alky/Meth kit from Livernois and trying to gather as much information/tips/help about fellow SHO owners who gave into the meth-bug.

Links, replies, suggestions, etc...all will be greatly appreciated.

 

[BamSHO]

http://www.ecoboostownerforums.com/index.php?/topic/404-bpd1151s-meth-injection-install/

http://www.ecoboostperformanceforum.com/index.php?topic=1751.0

http://www.ecoboostperformanceforum.com/index.php/topic,524.0.html

 

[BamSHO]

These are the ones I am currently looking at and using. I'm installing the same kit now.

 

[Boosted Sho]

I did my snow stage 2 install. At first up front then revised it to the rear

so I used my tire pump foam to mount my pump tank mounted above the pump. And bot below my tap in point on my throttle body.

I used the wire wrap goes insert the rear seat along the side to the firewall

so to under the dash snow came with a cool little clip for power at fuse box for the system

there is a rubber boot on the fire wall that I run my wires and tubing still wrapped from to back

took awhile to get this but worth it

boost tapped in and meth running across the back of the strut brace

tapped in to the intake on the factory circle its good there lil close the the valve cover but nothing touches

controller is mounted on the column left side not in the way. Fairly easy I put plugs on all my wiring for easy removal soldered and shrink wrapped all connections. Using 100 meth and a #6 625 ml nozzle. Tuned by Torrie @unleashed
Very pleased with this kit.


Sent from my iPhone using Tapatalk