Starter #4???

[coldsho]

when tryin to start the key goes all the way forward n nothin happens,no startin or lights or clicks or anything. i can try it a dozen times n nothin!! back it all the way n try again n it again and it works fine!!!! what i break now??? hope itnot another starter or something around that area

 

[sdpatt]

Sounds like the ignition key switch is suspect.

<small>[ October 24, 2002, 02:06 PM: Message edited by: sdpatt ]</small>

 

[Mr Anonymous]

Sounds more like the lock cylinder or ignition switch than a starter.

 

[coldsho]

just pulled a 6-3-4 code, what is that???

 

[Mr Anonymous]

coldsho:
just pulled a 6-3-4 code, what is that???

The definition for DTC 634 is: Transmission Range (TR) voltage higher or lower than expected.

This can be a result of the PCM detecting that the TR sensor is out of Self-Test range when the gear selector is in Park, or that the PCM has detected an invalid combination of transmission range switch states. (IOW, the Park/Neutral Postition switch and the MLP (Manual Lever Position) sensors disagree as to where the shift lever is.)

Sounds like you could have a bad MLP sensor on the tranny, a bad PNP sensor, or the shift linkage may just require adjustment.

This could also be the reason you're experiencing starting problems.

 

[coldsho]

when the key turns it seems like everything else works, eletronics n stuff! just no engine!!!

 

[coldsho]

and it doesnt matter wheather its in park or neutral