No Spark???

[Andrew Tilson]

I fixed my compression problem and now I have no spark, cps seems to be working I have a tach reading. and it had spark before I tore the thing apart. ideas on where to go from here???

 

[Andrew Tilson]

also the three codes that were present before I started are now all gone it has no codes in the system

 

[fredhurderjr]

Did you plug the DIS module back in? Did you disconnect the computer's ground? Just a thought.

<small>[ June 29, 2002, 12:07 AM: Message edited by: fredhurderjr ]</small>

 

[Andrew Tilson]

DIS is plugged in even tried getting a new one, where is the computer's ground? and I will go check that

 

[Andrew Tilson]

My DIS is grounded at least according to my ohm meter. if the computer's ground was bad then wouldn't it not be able to go into diagnostic mode?

 

[jcostantino]

Computer ground is a single connector from the negative battery terminal to a barrel connector that snaps apart and should be clipped to the right-side strut tower.

Jeff

 

[Andrew Tilson]

I fixed it!!!

I replaced the crank sensor even thought the tach was moving I desided to have autozone test it while I could still get to it, it came out bad and upon closer inspection I can see that the wires going into it were quite frayed, replaced it and now it runs like a scalded cat! I had forgotten just how freaking quick this car is, now all I have to fix is that damn oil pan leak... but that can wait for another day