need intake runner control for my 3.4 V8

[bigsho1]

Does anybody know of an after market or OEM runner control, took my car through emissions and it thru that code for it, had it double checked, the dealer said that part is noy availible, I nedd help finding one.

 

[Johnlemon]

just disconnect it, problem solved!

really common problem with v8 shos, the cable from the IMRC and butterflies snaps and causes a DTC.
another cause is a broken plastic gear inside the box


http://www.v8sho.com/SHO/imrc.html

 

[LOUDSHO92]

Send us an email at SHO Source. We have a couple of good used ones.

 

[stephen newberg]

Either of the above will work. At this point there is pretty good evidence that wiring open the secondaries so they never need to be considered again has no negative effect except making starting a bit more difficult in very cold weather. Then, after you clear the code the next time it appears, you will not see it again. Alternatively, replacing the cable and box via scrapped cars should fix you up.

pax, smn

 

[SHO U UP]

You can also use a DOHC V-6 Taurus one as well. IIRC, one of the holes don't line up on the mounting area but I have used them in the past. Hit up a local junkyard for one.

 

[newshofan]

Just unplug it and pull the box off save a pound or two and wire them open. Or remove them like i did. The starting on really cold really isnt as bad as it sounds. Maybe a lil rough for a min or two in my experience.
If you replace the box make sure you clean the secondaries good otherwise youll end up with the same problem again. Id install a catch can too. Which will help the secondaries and the intake from gumming as bad