Need help identifying this hardware....

[Devin]

Can anyone help me with these items? I'm not holding out too much hope, but these ones didn't get thrown into labeled bags. Here goes:

Thanks!

<small>[ March 14, 2004, 10:41 PM: Message edited by: Devin ]</small>

 

[DHMag]

top pic - 1 is the wire loom support that goes on the rear bank of the engine. i removed mine when changing valve cover gaskets and never reinstalled it. 2 are the "washers" for the tops of the factory subframe bushings. i cant make out 3.

bottom pic - 1 is a trans to engine stud. cant make out 2 or 3.

 

[Dr. Tweak]

Bottom 3, isn't that the temp sender unit? Goes right next to the thermostat?

 

[Devin]

Okay, number 2 on the bottom pic I think came out of the CV shaft. It was covered in that nasty greyish oil stuff.

I think you are right about the temp sending gunit, but shouldn't it have room for more than one wire?

<small>[ March 14, 2004, 11:44 PM: Message edited by: Devin ]</small>

 

[Jr's Sho]

On the bottom pic, number 1 is the bolt Dale said number three is the temp sending unit. It only has one wire.

 

[Dr. Tweak]

There is another temp sender unit, that one is the one for the dash, there's another one on the right of the thermostat that has two wires, that's for the computer.

thumb