intake clamps sizes??

[Dylan]

Hi I have silicone couplers on my intake and wanted to replace the oem clamps for some Tbolt style clamps. But i wanted to know what sizes i should get. Does anybody know the three different sizes?

 

[hawkeye18]

dangit, I know the big one that connects the surge tanks is 2.5"... I'll have to get back to you on the others.

 

[Dylan]

dangit, I know the big one that connects the surge tanks is 2.5"... I'll have to get back to you on the others.

I think the biggest one, closest to the TB is bigger than that. perhaps the two near the PS res. are 2.5. I'm thining the little ones on the runners are 2".
This is for my dads car, who doesn't live with me, or else I would just go out their and measure them up real quick.
But please get back to me once you figure them out.
Thanx alot

 

[itwonder]

Here is some information I copied a while back that might help:


"Found a reasonable substitute for the hose clamps used on the manifold runners. They're an all stainless narrow-band unit made by Breeze, part number MAH-20. Runs from 1.18" to 1.75" diameter, about $0.90 each. They're not fully lined as the British-made OEM clamps were, but will serve the intended purpose.

Unfortunately, Breeze has nothing larger then 1.75" in a narrow band unit, so I'm still looking for clamps that will fit the connectors on the crossover tube and the splice adjacent to the throttle body. One could always splice together 2 small clamps to make a larger one."

"Here is the original manufacturer of clamps for the SHO motor":

Norma Products
31132 Century Drive
Wixom, MI 48393
Phone: 248-668-9510
Fax: 248-668-9523
Website: www.norma.de

 

[Dylan]

Bump,

Anybody got the info for these sizes I need??