I need a new ..this *PIC*

[MOSHO92]

I have been having a lot of play in the shifter **** (2 inches) going side to side without actually engaging the transmission. I was under the car and noticed that this bushing is dried up and shrunk. Is there a direct replacement bushing, or a bolt i can replace or tighten? Any advise, i think this will really help with my shift feel.

 

[DHMag]

if im not mistaken, ask sdpatt. i believe he drilled out the shaft and replaced that bushing. im thinking he installed a bronze bearing/bushing or some type of hard, but wearable material. but like i said, im not 100% sure.

 

[MOSHO92]

So there is no direct replacement for it? Is there even a way to disassemble that unit?

 

[Jr's Sho]

The only way is to drill it out and after installing two bushings, to use a bolt and nut. Scott did a write-up on it with some pics, you should be able to find it in the search archives.

 

[MOSHO92]

Ohh, i found the write-up. Thanks again Scott. thumb

 

[sdpatt]

You are welcome.