Hot Pipe install help

[95ShoOff]

So i just got the hot pipes in and need a little help. The new pipes dont have spots for these sensors. Im not an expert by any means , just want to kno how about installing everything. Also have the tial blow of valve and not sure what hose i run to it. I wish there was a shop near me that could install everything.

 

[EcoBoostSHO]

So i just got the hot pipes in and need a little help. The new pipes dont have spots for these sensors. Im not an expert by any means , just want to kno how about installing everything. Also have the tial blow of valve and not sure what hose i run to it. I wish there was a shop near me that could install everything.View attachment 6662

Those sensors are actually your factory blow off valves. I have hot pipes but went with factory mounts on them. Since you have a Tial you would need to just tie those out of the way as I believe if you disconnect them you will get an engine light. The Tial will obviously serve as your BOV but I'm unfortunately not familiar with how to hook it up on the SHO....hope that helps some. I'm sure someone will jump in and help soon.

Sent from my XT1650 using Tapatalk

 

[CCXVI]

Those are not sensors, they're your blow off valves. The hoses shown are what you run to them, but I'd personally cap them on the other side and leave the BoV side open.

 

[SM105K]

Those are not sensors, they're your blow off valves. The hoses shown are what you run to them, but I'd personally cap them on the other side and leave the BoV side open.

This, makes it actually sound like a turbo car...lol.