Front Spindle/Knuckle

[bluemoney]

I have 2 90 MTX SHO's and a 94 ATX. I have a left from spindle/knuckle that is worn real bad were the brake pads sit it has 355,000 miles. Does anyone know if all the parks from the 94 will fit on the 90, like the knuckle, strut, caliper, rotor and pads. Thanks Much Larry

 

[Irish Pride]

94 and 90 are completely different. 94 uses a caliper and bracket setup where as the 90 caliper bolts directly to the knuckle.

That being said, you can swap the 94s to the 90 no problem as long as you swap the brakes too. Everything else will mount up the same. You can also do the 96 bigger brake upgrade if you want but keep in mind that it does require at least 16" wheels to clear.

-Chad

 

[bluemoney]

94 and 90 are completely different. 94 uses a caliper and bracket setup where as the 90 caliper bolts directly to the knuckle.

That being said, you can swap the 94s to the 90 no problem as long as you swap the brakes too. Everything else will mount up the same. You can also do the 96 bigger brake upgrade if you want but keep in mind that it does require at least 16" wheels to clear.

-Chad

Thank you very much I think I'll take everything from the 94 and put on the 90 that way the pads won't wear the knuckle out. I'll start using the 94 for a parts car. I have 17" on all 3 SHO's.

 

[sperold]

Another bonus for the swap from 94 into the 90 is, you do not need to press out (and in) the wheel bearing on the 94 hub.