engine light ?

[93 Fo SHO]

How do you pull codes on the SHO using a jumper wire?I can get them on my Iroc-Z but not sure on the taurus. My check enging light comes on when its warm outside I think. Cause I go to work in the morning (about 10 miles) it dosent come on but when I leave in the afternoon it comes on right away(within the first few miles).

 

[Jeremy Hohn]

Well, on my 93 atx, you take the EEC test module off of the passenger side firewall, unfasten the cover and look at all the plugs it will look like this

- -
- - - - or someting like that... then take a regular wire and put it in the upper right part of the "pyramid" I like to call it, and jump it over to the test area in the corner of the assembly. Go to shotimes if I confused you....

Read about it here... http://www.shotimes.com/SHO3eeccodes.html http://www.shotimes.com/references/eecarticle.TXT http://www.shotimes.com/SHO3eeccodes3.html

------------------
Jeremy

1993 atx 122k miles
-PIAA headlamp bulbs (thanks Fratperformance)
-fish tanks installed
-fog lamp mod w/ blazer fog lamps
-6" 5% tint border on windshield
-black body filled lettering
-wclewis "powered by yamaha" badges
-Sho Shop Cold Air Induction Kit
-Lund blackouts front and back
-cincysho colgan half bra with "SHO" lettering
-KVR chrome cadmium plated rotors with carbon fiber pads
-Sho Shop cat back system with magnaflow chrome tips
-Performance Plus y-pipe
-TX personalized plates "SHO FUN"
-Shoshop underdrive pulleys
-Shoshop 80mm MAF
-60k completed by Sdpatt
-Redline atx tranny fluid and water wetter

[This message has been edited by Jeremy Hohn (edited 11-05-2001).]