Diff problem

[anarchy04]

Diff problem / reinforcing

I'm not sure if the diff is going or what but like when I was looking in the hole for the drivers side CV one pin is in its place then I can only see half of the other one. could someone post pics of what it is supposed to look like and possibly how to reinforce the stock one because I think I am going to tear it apart.

 

[Ishodu]

In there there is 1 long pin that goes from each side and 2 short ones they don't touch in the center there is prolly 1/8-1/4" gap.
Take a pic for us to take a look at.

 

[dantheman68]

it might mean the one pin's retainer has failed... id quick get it out and buy a diff from bittersweet SHO before the diff tosses the pin through the case and ruins that too

 

[anarchy04]

Yeah one of the small ones was eating its way through my case, saved it in time though. Could someone possibly post a diagram of how this tranny goes back together because there are two little pins that fell out of place when I was taking it apart and I can't figure out for the life of me where they go. Also, to reinforce it I was going to just MIG weld the two short pins to the long one right in through the axle hole, that wouldn't cause any problems will it?