clutch switch????

[lowc]

guys another atx to mtx swap question im trying to figure out how to splice in the clutch switch? there is no visible connectors tucked up under dash so do i just by pass the nutral safty wire off the ignition?

 

[rubydist]

if you did the mod to the mlps on the trans, then you don't need the clutch switch - it will crank whenever you try. if you need the 'safety' of the interlock switch, you run the wires off the mlps to the clutch switch.

 

[lowc]

Sry forgot to add erlier that I am useing the original 3.0 harness from my 92

 

[rubydist]

if you are using the 3.0 harness under the hood, you will need to either use the 3.0 dash harness or re-wire a bunch of the wires at that large connector under the mafs. part of what you will need to re-wire is to jumper the clutch interlock switch, if you go that route.

 

[lowc]

is that the grey square one maybe 12-16 pins?