Car alarm installation help?

[SHOtime3]

I purchased a Omega Fredom 400 car alarm for $10 at a liquidation sale. I don't have the instruction booklet but the wires are labled. I was wondering if anyone out there could tell me where the following wires would need to go in the car?

Red = +12V (what power source shoould I use?)
Yellow = Acc +
Gray = Vallet Switch (I have this one under control)
Orange = Starter -
Blue = Trigger - (I think this may be for my door locks)
White = Light +
White = Light +
Pink = LED + (Another I have under control)

I have another problem if anyone can help just click may on my name and check my post. I only have three so it shouldn't be hard to find.

http://www.cardomain.com/ride/577946

My mock up r33 bumper

 

[flakedawg]

the starter ign and power all get hooked into the thick wires in the steering colmn. use a multi meter to test them . you power is hot all the time the started only 12v during start and the ign is hot as soon as the key is turned and stays on during crank. the orange usally goes to a starter **** relay.there should be one wire that goes to the door trigger wire and you should have a parking light wire I can get the exact wires if you still need them when i go to work tomorrow

 

[SHOtime3]

that would be great

 

[SHOtime3]

Where is the ignition harness and drivers kick panel located?

 

[thecrew2999]

check the how to section they have all the wiring needed for all year SHOs on there that will tell you everything you need