Best place to buy Aluminum subframe brushings

[dmoo21]

where is the most cost effective place to pruchase Al subframe brushings?
-Dan

 

[Ishodu]

Just look though our vendors on the site, as long as you get good cup bushings you are good. Just say far away from ring style bushings, like miles away no matter what the price.

 

[SableSal]

What's the difference? I was curious on purchasing a set for the Sable.



Sal

 

[NotSoSlowSHO]

ust say far away from ring style bushings, like miles away no matter what the price.

lets not start this up again.

 

[dmoo21]

ive only seen cup, what are ring style ones, i do not know or know the difference?
-Dan

 

[92sho16]

lets not start this up again.

I dont think you can get anything but cup style now so i dont think/hope this threads turn into which is better.

 

[Mr Anonymous]

I believe that Josh at http://www.shonutperformance.com is the only place that now regularly stocks cup-style aluminum SFB's, and I'd highly recommend both him and his bushings.

 

[LeddZepp8687]

Yea I just ordered ASFBs from SHOnut and cant beat the price!! Also had them in stock too!

 

[grailgolf]

Alsfb

Got mine on Ebay - $88.99 + s/h - Excellent quality, labeled front & rear as promised -Very satisfied

 

[NiNeTy Fo SHO]

I sent ya a PM.

 

[ManySHOs]

Got mine on Ebay - $88.99 + s/h - Excellent quality, labeled front & rear as promised -Very satisfied

They were labeled? Mine are the same, all four corners.

I have the Jon Best/ROMAR (or is it JOMAR?) set. Very rare ALSFB's, very unique. One day they will be worth ...something..They were supposedly anodized red at one point; who knew that PB Blaster could strip anodization?

haha

They are cup style as well.

Ian

 

[SHO92]

So are my JOMAR bushings worth even more since they were the original ones that Ron Porter had JOMAR make? I also have a JOMAR h-brace, do I get more money for the matched set?

 

[SableSal]

I got a set of these.

and was curious if these will work on the Sable's front and rear.

Here are a couple of more pics.

Yes, they are used. Think they still are good? They got a couple of chip on em. Nothing major though.





Sal

 

[NotSoSlowSHO]

those are fine.

And yes, they will work on a sable.

 

[SableSal]

Thanks a lot! Also, any one know torque specs for these? Standard is 75lbs-ft. Any difference with the ASFB?



Sal

 

[NotSoSlowSHO]

I torque mine to 95.

 

[SHOZ123]

I tighten mine as tight as I can get them.

 

[Ishodu]

I am running like 125ft lbs on mine.

 

[SableSal]

I will torque the new ones to 100Lbs-Ft then. Seem to be around average.

Thanks guys!




Sal

 

[ManySHOs]

I will torque the new ones to 100Lbs-Ft then. Seem to be around average.

Thanks guys!




Sal

Go back and check them periodically. They can loosen up over time.

Ian