A/C Clutch Problem. Quick help needed.

[SinisterSHO]

A/C Clutch Problem. Quick help needed. No 56k

So, my clutch was bad, and just finally got worse. After I finally get the outside plate thing off, the pulley where the belt goes comes right off, good. Well, It completely seperated from the bearings. I now I have the the bearings for the pulley inside the rest of the clutch. And upon looking at it, I'm thinking the new one from Advanced wont work. Whats on the car is just a shaft with a key on it, the new one has a lot of teeth for adjustment.

This is what I have left on the car

What should be on the car.

old

new

So, any suggestions on getting the rest of this off, and anyone had problems with new clutches not fitting? thanks

 

[SinisterSHO]

I did get a different clutch with the right keyway, except the whole outter plate looks different. It esentially looks like this one. http://www.partsamerica.com/PartDet...=FAA&MfrPartNumber=47874&PartType=385&PTSet=A

 

[AutoSHO]

That clutch will work. However, your pulley broke in half (my ATX did exactly the same thing) so you'll have to buy a new pulley as well.

 

[SinisterSHO]

Well, after I turned my 3 pc. clutch into 5, I finally noticed the snap rings, which became a huge pain. Finally got everything back together, and the car runs great.