I wanted to go out and use my autoanalyzer to test certain sensors and electrical parts. However, I'm not sure what exactly I should be testing for. Like if I wanted to test the functions of my maf sensor, where should my readings be close to; the same for other sensors and their readings also???
I lost the instructions for my Actron CP7665 meter, so I'm sort of clueless about using it, although it did help me to discover that my CCRM was bad.
I'll run my codes again also, as I'm still way past taking my emission test.
It's looks like this: http://www.actron.com/product_detail.php?pid=16156
Thanks!!!
I lost the instructions for my Actron CP7665 meter, so I'm sort of clueless about using it, although it did help me to discover that my CCRM was bad.
I'll run my codes again also, as I'm still way past taking my emission test.
It's looks like this: http://www.actron.com/product_detail.php?pid=16156
Thanks!!!
Last edited:
