luigisho
SHO Member
Anyone have the correct torque specs for y-pipe to exhaust man. studs and oil pan bolts? I might as well ask about the starter torque specs. while I'm at it. Thanks.
torque specs?
- Thread starter luigisho
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Yamaha V6
SHO Enthusiast
Y-Pipe studs...
"Tighten until JUUUUUUST before you break the stud..."
(j/k)
I'll check the books.
<small>[ October 29, 2002, 08:58 PM: Message edited by: Yamaha V6 ]</small>
"Tighten until JUUUUUUST before you break the stud..."
(j/k)I'll check the books.
<small>[ October 29, 2002, 08:58 PM: Message edited by: Yamaha V6 ]</small>
luigisho
SHO Member
Thanks Fred. While you're in there I think i'm going to replace the oil pickup tube gasket with an egr gasket. Is there a specific torque or is it just nice and snug?
Off topic- I was meaning to ask you about which intercooler you used in Jezzie.
Off topic- I was meaning to ask you about which intercooler you used in Jezzie.
Similar threads
