Spinning front pass subframe bolt.

[93rev2sev]

Here is a picture I mocked up to show everyone how I held the spinning washernut on my 93MTX yesterday. They grey that I added is a drawing of a tire iron holding the nut with the bolt supplying leverage against the uptunred lip of the washernut. The hole was cut some time ago by the last sucker (me).

I had my brother work the rachet while I applied force to the tire iron; definately a 2 person job.

<a href="http://s90.photobucket.com/albums/k266/wolf99tpc/?action=view&current=frontpassSFbolt.jpg" target="_blank"><img src="http://i90.photobucket.com/albums/k266/wolf99tpc/frontpassSFbolt.jpg" border="0" alt="Photobucket - Video and Image Hosting"></a>

 

[93rev2sev]

oops...heres the pic

 

[Minnesho]

i had to do the same thing when i dropped the subframe on my old 92. had a buddy use a large pry bar to hold the captured nut (which had become uncaptured). when i reinstalled it it was with a recall kit so it was a piece of cake.

 

[93rev2sev]

2 recall kits on their way from shonut

 

[Yamaha V6]

Sawzall / Hacksaw + magnet to get the remnants out the access hole on the inside.

 

[93rev2sev]

Yep, that works also. This method saved my a$$ as I had to get it back together without new hardware - not recommended.

 

[NotSoSlowSHO]

Sawzall / Hacksaw + magnet to get the remnants out the access hole on the inside.

ditto that!

Then install fresh hardware.