speed sensor

[WhiteSHO625]

hi i got a 91 sho and i was wondering how to change the speed sensor can anybody help me?

 

[rubydist]

the vss sits on top of the trans, where the speedo cable attaches.
remove the speedo cable, remove the wire connector to the vss. there is a nut that attaches the vss to the top of the trans, you need to remove that. then the vss just slips off. assembly is reverse.

 

[intimdatr]

Its a pretty simple job, but is sorta frustrating to do with the wires and such that will make it harder to get to and see what your doing.

 

[WhiteSHO625]

how do i remove the speedo cable safely?

 

[rubydist]

you just pull it up. it is held in place with a hairpin type of spring clip - it just snaps over the notch in the end of the cable, so you just pull on the cable to release it.

 

[frank.j.costell]

I am having a hard time locating the assembly. Can anyone explain or post a diagram/picture of the location? Thanks

 

[jmpSHO2nd]

I am having a hard time locating the assembly. Can anyone explain or post a diagram/picture of the location quan ao tre em? Thanks

MTX or ATX? Both sit on top of the transmission however the MTX is a lot easier to replace.

 

[rubydist]

follow the speedometer cable down to where it attaches to the trans.

a pic is difficult because its hidden under a couple bundles of wiring, a few coolant hoses and assorted other stuff. its hard to find for the same reasons.

 

[intimdatr]

I'll try to get a pic.

 

[intimdatr]

Here's the best i could do. Its close to the fire wall and next to the rear bank exhaust header. You're looking for a connector around this speed-o cable.